armeb-unknown-linux-gnueabi

Tier: 3

Target for cross-compiling Linux user-mode applications targetting the ARM BE8 architecture.

Overview

BE8 architecture retains the same little-endian ordered code-stream used by conventional little endian ARM systems, however the data accesses are in big-endian. BE8 is used primarily in high-performance networking applications where the ability to read packets in their native "Network Byte Order" is important (many network protocols transmit data in big-endian byte order for their wire formats).

History

BE8 architecture is the default big-endian architecture for ARM since ARMv6. It's predecessor, used for ARMv4 and ARMv5 devices was BE32. On ARMv6 architecture, endianness can be configured via system registers. However, BE32 was withdrawn for ARMv7 onwards.

Target Maintainers

@WorksButNotTested

Requirements

The target is cross-compiled. This target supports std in the normal way (indeed only nominal changes are required from the standard ARM configuration).

Target definition

The target definition can be seen here. In particular, it should be noted that the features specify that this target is built for the ARMv8 core. Though this can likely be modified as required.

Building the target

Because it is Tier 3, rust does not yet ship pre-compiled artifacts for this target.

Therefore, you can build Rust with support for the target by adding it to the target list in config.toml, a sample configuration is shown below. It is expected that the user already have a working GNU compiler toolchain and update the paths accordingly.

[llvm]
download-ci-llvm = false
skip-rebuild = true
optimize = true
ninja = true
targets = "ARM;X86"
clang = false

[build]
target = ["x86_64-unknown-linux-gnu", "armeb-unknown-linux-gnueabi"]
docs = false
docs-minification = false
compiler-docs = false
[install]
prefix = "/home/user/x-tools/rust/"

[rust]
debug-logging=true
backtrace = true
incremental = true

[target.x86_64-unknown-linux-gnu]

[dist]

[target.armeb-unknown-linux-gnueabi]
cc = "/home/user/x-tools/armeb-unknown-linux-gnueabi/bin/armeb-unknown-linux-gnueabi-gcc"
cxx = "/home/user/x-tools/armeb-unknown-linux-gnueabi/bin/armeb-unknown-linux-gnueabi-g++"
ar = "/home/user/x-tools/armeb-unknown-linux-gnueabi/bin/armeb-unknown-linux-gnueabi-ar"
ranlib = "/home/user/x-tools/armeb-unknown-linux-gnueabi/bin/armeb-unknown-linux-gnueabi-ranlib"
linker = "/home/user/x-tools/armeb-unknown-linux-gnueabi/bin/armeb-unknown-linux-gnueabi-gcc"
llvm-config = "/home/user/x-tools/clang/bin/llvm-config"
llvm-filecheck = "/home/user/x-tools/clang/bin/FileCheck"

Building Rust programs

The following .cargo/config is needed inside any project directory to build for the BE8 target:

[build]
target = "armeb-unknown-linux-gnueabi"

[target.armeb-unknown-linux-gnueabi]
linker = "armeb-unknown-linux-gnueabi-gcc"

Note that it is expected that the user has a suitable linker from the GNU toolchain.

The rustc book